Header Ads

Eleaf Invoke User Manual


Power on/off: push forward to open the battery cover, put two high-rate 18650 batteries in correct way into the device and finally close the battery cover. The device can be powered on or off by pressing the fire button 5 times. The battery levels of battery 1 and battery 2 are respectively displayed on the screen.

NOTE:
1.Please be careful not to use batteries with torn casing as it is a safety hazard.
2.Please make sure you are using high-rate 18650 batteries whose continuous discharge current should be above 25A. 3.Before using, please choose the correct mode and adjust the wattage to a proper range according to your atomizer.

Inhaling: when the device is powered on, long press the fire button to take a puff.

Charging: the 18650 batteries can be charged in the device through USB port via wall adapter or a computer or charged with an external battery charger.

Firmware upgrading: the firmware can be upgraded by connecting the device with a computer through the USB port via a micro USB cable.

General operations:



Supplementary Instructions
Parameters settings: under VW mode, the wattage can be adjusted simply by pressing + or - button; when TC(Ni, Ti, SS)/TCR(M1, M2, M3) mode is selected, the temperature can be adjusted simply by pressing + or - button while the wattage can only be adjusted under SET-POWER menu.

Note:
1. The TC-SS mode is especially designed for stainless steel 316 type coil only.
2.TC/TCR mode only supports a maximum of 1.5 ohm. The device will automatically switch to VW mode when the resistance is larger than 1.5 ohm.
3.When Kanthal wire is applied under TC/TCR mode, the device will also automatically switch to VW mode.

Stealth function: when stealth function is activated (STEALTH ON), you can vape with the display off and you can press the fire button once to see current setting.

Sub-parameters: sub-parameters include Puff (total vaping puffs), Time (total vaping seconds) and AMP (current amp). You can choose one of them to be displayed on the main interface. 

Custom logo: download the firmware file of the device on our official website, plug the device in with USB cable to a computer, and double click the EleafUpdate.exe. Then click “LOGO” and open the image you made to put it in the device. When LOGO is set to be ON, the image will be displayed on the screen. 

Note: please make sure the image you choose is a monochrome image of 64*40 pixels in the format of bmp. 

Preheat function: preheat function allows the device to quickly heat up the coil at a higher wattage within certain time limit. This function only works under VW mode. When preheat function is activated, the color of letter “w” on main interface of VW mode will change from white to black. 

USB charge function: screw an RC adapter (not included) on the device and connect it with another e-cigarette mod or cellphone by a USB cable. When USB charge function is activated,the device will be able to charge other e-cigarette mod or your cellphone. 

Timeout duration: once the duration is set (like 5 seconds), when you hold the fire button and vape over the pre-set time, it’ll display Over 5S protect and shut down automatically. Press the fire button 5 times to reactivate the device. 

About TCR mode: under TCR (Temperature Coefficient of Resistance) mode, the device can support different temperature control coils within different TCR value ranges and you can set the TCR at different values within proper range. 

Following are different TCR value ranges for different coils for your reference:
Note: 
1.The TCR value in the sheet is 10 multiplied of the actual TCR.         2.Our total range of TCR value is 1-1000.

Indications and Protections 
Atomizer Low Alert: when the resistance of coil is lower than 0.1ohm in VW mode or lower than 0.05ohm in TC modes, the screen will display “Atomizer Low”. 

Atomizer Short-circuit & No Atomizer Protection: when atomizer short-circuit occurs, the screen will display “Atomizer Short”. The screen will display “No Atomizer” when there is no atomizer connected. 

Low-voltage Protection: when the voltage of the batteries is below 3.1V, the screen will first display “Battery Low” and then “Lock”. Charge the batteries to reactivate the device. 

Temperature Protection: in TC modes, when the actual temperature of coil reaches the set temperature, the screen will display "Temp Protection". You can continue to use the device normally. 

Temperature Alert: if the temperature of device is over alert temperature, the output will shut off automatically and the screen will display “Device Too Hot”. You can continue to vape after it cools down. 

Weak Battery Alert: in all vaping modes, when the device is working with an atomizer and the voltage of the batteries drops below 2.9V, the screen will display “Weak Battery”. Meanwhile, the output power will be reduced accordingly. 

Imbalanced Alert: if the voltage difference between two batteries is equal to or more than 0.3V, the device will display “Imbalanced Batteries” when plugged in. Please fully charge the batteries externally or replace the batteries with freshly charged batteries. 

Check Battery Alert: if the batteries are installed incorrectly, the screen will display “Check Battery”. 

Charge Error Alert: when no current is detected in charging state, the screen will display “Charge Error”. 

Check USB Alert: if the voltage of the USB charger is equal to or more than 5.8V, the device will display “check USB” when plugged in or vaping. 

Warnings 
1. Please keep out of reach of children. 
2. This product is not recommended for use by young people, non-smokers, pregnant or breast-feeding women, or persons who are allergic/sensitive to nicotine.

Contra-indication 
1. Do not attempt to repair the product by yourself as damage or personal injury may occur. 
2. Do not leave the product in high temperature or damp conditions, otherwise it may be damaged. 
3. Do not use this product for other purposes except only for vaping and don’t swallow the e-liquid.

Possible Adverse Effects 
1. This product may be hazardous to health and contains nicotine which is addictive. 
2. For people with adverse reaction after using this product, it is recommended to use the e-liquid with lower nicotine content or no nicotine.




No comments

Powered by Blogger.